- Guaranteed to solve moisture vapor
problems as high as 27 to under 3 lbs.
- Easy application
- Low per square foot cost
- Alkali, mold, and Mildew resistant
|
- Cures new concrete
- Eliminate call backs and repairs
- Warranty available
- No shot blasting required
|
LEED Guide - MoistureBloc®
Vexcon's MoistureBloc Vapor Reduction Systems
Moisture can come from ground water, atmospheric conditions, repeated floor cleaning, or the concrete itself. When excess moisture is present in concrete, a common result is flooring adhesive failure. Wet adhesive can smell and ooze between tiles, sheet flooring can indent or pop out, and carpeting can lift up. In some cases mold, mildew, and floor lifting can cause health and safety issues. Vexcon offers a wide range of product solutions specifically designed to meet the particular requirements of any flooring installation. Products and Features
| MoistureBloc One Step |
MoistureBlock Universal |
Reduces moisture vapor readings ranging
from 9 to under 3 lbs.
Very low per square foot cos
Easy one coat applicationAdhesive can
be applied after 12 hours
Minimal odor
LEED point standards
|
Reduces moisture vapor readings ranging
from 9 to under 3 lbs.
Can be used with reactive and non reactive adhesives
Adhesive can be applied after 12 hours
Easy one coat application
Minimal odor
Can be used interior and exterior
Meets all California VOC regulations
LEED point standards |
MoistureBloc Emulsion
Vapor Reduction System |
MoistureBloc Vapor
Reduction System FT |
MoistureBloc MX |
Reduces moisture vapor readings ranging from 15 to under 3 lbs.
Minimal order
Can be used with reactive and non reactive adhesives
LEED pont standards |
Reduced moisture vapor readings ranging from 15 to 3 lbs.
Fast track - adhesive can be applied after 18 hours
Low odor
Can be used with reactive and non reactive adhesives |
Reduced moisture vapor readings ranging from 27 to 3 lbs.
Maximum protection
Cost effective |
|
